Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
GB
Repair any damage before starting the
motor. Contact a specialised after-sales
centre.
C19 - In the event of the machine pro-
ducing abnormal vibrations, stop the
motor and immediately seek the cause.
Vibrations normally indicate a problem.
C20 - Stop the motor:
20.1 Every time you leave the
TILLER.
20.2 Before filling up with petrol.
20.3 Before adjusting the height of the
ploughshare (wait until the cutters have
stopped).
C21 - Before lifting or lowering the
wheel.
C22 - Before cleaning or removing
material from the cutters.
C23 - Move the throttle to minimum
when switching off the motor and close
the petrol cock (if fitted) after stopping
the motor.
MAINTENANCE AND DEPOSIT
D1 - Make sure all the nuts and screws
are tight so the machine is always in
good operating condition.
D2 - Never place the TILLER in
closed premises with petrol still in the
tank. Petrol vapours could reach an
open flame or sparks.
D3 - Wait for the motor to cool down
before storing the machine in closed
premises.
D4 - To reduce fire risks, keep the mo-
tor and silencer free of grass, leaves or
excess grease.
D5 - For safety reasons, replace worn
or damaged parts. Only use original
spares. Spares made by other manu-
facturers could adapt badly and cause
16/
013
TILLER OPERATING MANUAL
damage and danger.
D6 - If the tank has to be emptied, do
the job in the open.
D7 - Periodically check, or have
checked by an after-sales centre, the
tightness of the cutters and motor sup-
port screws.
D8 - The TILLER cutters are
sharp and can cut the skin. Take every
precaution when working near or on
the cutters.
3. DESCRIPTION OF MACHINE
PARTS
DESCRIPTION (Fig.1)
A)
Cutter rotation control lever.
B)
Cutter control cable adjuster
C)
Throttle lever.
D)
Handlebar lock knobs
E)
Starting cable handle
F)
Fuel tank cap
G)
Engine oil topping-up cap
H)
Starter
I)
Plug cap
L)
Silencer
M)
Combustion engine
N)
Cutter guard
O)
Work depth ploughshare
P)
Cutters
Q)
Reduction unit
R)
Transport wheel
4. ASSEMBLY (F
A) - HANDLEBAR PLATE
Fit the handlebar retention plate (1) on the TILLER
chassis using the 4 screws (2) and secure by
means of the nuts (4).
.2)
IG
Publicidad
Tabla de contenido
