Effect Parameters - DJ-Tech D JM-303 Manual De Instrucciones

EFFECT PARAMETERS

Name BEAT/BANK button parameters
Sets delay time of 1/2 to 4/1 per 1
ECHO
beat of BPM time
Sets change time of 1/2 to 4/1 per
TRANS
1 beat of BPM time
Cycle of flanger shift is set in units
FLANGER of 1/1 to 16/1 relative to 1 beat of
BPM
Cycle of cutoff frequency shift is
FILTER set in units of 1/1 to 16/1 relative to
1 beat of BPM
Cycle of phase effect shift is set in
PHASE units of 1/1 to 16/1 relative to 1
beat of BPM
Sets change time of 1/2 to 4/1 per
PAN
1 beat of BPM time
PITCH Select -50%~+100% of pitch
REVERB Select 0%~100% of reverb
Select bank of recording/
SAMPLER
playback of 4 beat source
Parameter X
(Beat button)
Setting range (unit)
2~2000 (ms)
25~32000 (ms)
100~32000 (ms)
100~32000 (ms)
100~32000 (ms)
30~32000 (ms)
-50~+100 (%)
0~100 (%)
7 sec. of max
recording for per
bank
8
Parameter Y
(Level/Depth fader)
Sets balance
between original and
delay sound
The duty cycle for a
square volume wave
Amount of effect
increases when fader
is pushed upward.
When fader is at
minimum, only
original sound is
output
Amount of effect
increases when fader
is pushed upward
Amount of effect
increases when fader
is pushed upward.
When fader is at
minimum, only
original sound is
output
The sharpness for
pan between left and
right channel
min m ost smooth
→
max → m ost sharp
Amount of effect
increases when fader
is pushed upward
Amount of effect
increases when fader
is pushed upward
Sets balance of
original sound and
recorded sample.
min O riginal sound
→
max S ample sound
→