Running In Manual Mode; Running A Program - HQ-Power VDPC054 Manual Del Usuario

press and hold A
press and hold SELECT.

7.2 Running in Manual Mode

You can use the controller to manually set DMX values using the faders.
Refer to the documentation of your specific DMX device for more information
on the exact function of the DMX channels.
1. From start mode, press B once to enter manual mode.
The dot blinks in the PROJ display, which indicates the device/page (1-9)
that is currently active.
2. Use UP and DOWN to select the desired device/page (1-9).
3. Move the faders to set the DMX channels of the selected device/page to
the desired values.
4. Repeat steps 2-3 until all DMX channels are set to the desired value.
5. To quit and return to start mode, press B once again.

7.3 Running a Program

Note: Creating programs is explained in § 8, Programming, further in this
manual.
To run an existing program, proceed as follows:
1. From start mode, press A once.
The dot blinks in the PROG display, which indicates the program (1-9)
that is currently active. The SCENES display shows the scene number that
is currently executed.
2. Use UP and DOWN to select the desired program (1-9).
3. Use fader 2 to set the speed of the program (duration of the scenes).
4. Use fader 1 to set the fade time between scenes.
Note: If the fade time is too long, the fade will not be completed before
the end of the scene.
5. To stop running the program and return to start mode, press A once
again.
7.4 Manually Overriding a Program
While running a program, you can still override the programmed scenes
manually for a specific device.
1. While the program is running, press B once.
The dot blinks in the PROJ display.
2. Use UP and DOWN to select the device/page that you want to control
manually.
3. Adjust the faders to manually set the DMX values for the selected
device/page.
V. 02 – 11/09/2013
VDPC054
7 ©Velleman nv