Checklist - HOESCH ERGO+ Instrucciones De Montaje

16

Checklist

On the basis of this checklist you can quickly and effortlessly deal with defects occurring in your whirl tub. Works
connected with the electric installation can only be performed by authorized experts in this field. Before commencing
electric works you should switch off the whirl tub from the power supply!
Defects
The blower is not working
The pump is not working
The massage stream
is getting weaker
GB
What you should do when ...
during whirl bathing foam appears?
— Immediately switch the Whirl system and Air-Injection off! Drain and rinse the bathtub thoroughly. Remember
to use only appropriate additives for bathing (the ones that do not foam and do not contain oils)!
you do not use the whirl tub or you are absent (e.g. you are leaving for a holiday)?
— In fact you do not have to make any special steps.
Like in case of all electric devices it is recommended to switch the device off with the master switch.
Getting ready to call the HOESCH customer service centre
If removing defects by yourself has not been successful, then before calling prepare the following information, so that the
customer service centre can find a solution as quickly as possible:
■
Product name/model signs
■
Article number
■ Factory number/serial number of the product (you will find it on the guarantee card, or on the control unit or on
the product itself)
Example:
■
Purchase date
■
Symptoms of the problem
22
Reason
Lack of the power voltage
230 V, 50 Hz
Burnt fuse
Dry-run protection is switched on
Released motor protection against
overheating
Control unit electronics
Drain valve
Massage jets
Fabr.-Nr.
HOESCH 0H7 00008
Remedy
Switch on the initial protection and/or the
current trip device (FI)
Exchange of fuse by an expert
Please fill the bathtub above the jets level
Let the motor cool down
Restart the motor, i.e. stop the current
inflow for approx. 1 minute
Clean the drain valve
Clean the jets