TRP Dynamic Instrucciones De Montaje página 25

TRP Dynamic
Assembly
Recommendations
• Before starting assembly, please read instructions and
follow them during installation process.
• Use the adequate tools for each operation.
Electricity
• Disconnect ignition key.
• Disconnect battery before starting assembly.
• Make sure electric components are securely connected,
checking their correct fitting.
!
If, during assembly, the unit becomes slanted or
the cabin is tilted with the unit mounted, wait for
at least 60 minutes from the moment the unit is
horizontal before starting up.
Documentation included
Mounting instructions
User´s guide
Troubleshotting
Warranty
The instructions regarding position are:
RIGHT: Passenger side
LEFT: Driver side
Torque (N∙m)
Thread
8.8
M6/100 10
Pipe assembly
Pipe
1/4"
3/8"
Caution
220.AA6.4001
220.AA6.4003
220.AA6.4002
220.AA1.0017
Steel Quality
Torque
10.9
13
Torque
Torque Tool
13-15 14 mm Wrench
15-17 19 mm Wrench
Ø10 Socket wrench
TOP 10 Cruciform screwdriver
Ø10, Ø17, Ø19 Wrench
Ø6 Allen key
Ø10 Ratchet wrench
Drill
Ø4, Ø6, Ø7, Ø9 Broach
Ø19, Ø22, Ø35, Ø48 Circular saw
Scissors
M6 Riveter
!
Installation personnel must have been duly trained with
regards to air conditioning in vehicles.
!
dirna Bergstrom shall be released from any liability
should failures occur as a result of inappropriate handling
or installation of equipment, or due to modifications or
replacements made without express authorisation from us
in writing.
!
Equipment pre-loaded with R-134a gas. Do not touch
the refrigerant gas circuit.
!
See the warranty procedure for the product included in
Troubleshooting.
10
!
See the unit's User Manual for the correct operation of the
remote control and the control panel.
!
The following should be provided to the user when
installation is complete: User Manual, Warranty and
Troubleshooting.
!
The unit does not comply with ADR regulations.
25
Air conditioning for vehicles
Tools
Symbology
Fragile
Beware of cuts!
Electrical hazard
! Warnings
EN ES