Technical Specifications; Accessories - Global garden products HTM 60 Manual De Instrucciones

12 IDENTIFICATION OF FAULTS / TECHNICAL SPECIFICATIONS / ACCESSORIES
EN
8. IDENTIFICATION OF FAULTS
PROBLEM
1) The engine
will not start
or will not
keep running
2) The engine starts
but is lacking
in power
3) The engine runs
irregularly and lacks
in power when
revved
4) The engine gives
off an excessive
amount of smoke

9. TECHNICAL SPECIFICATIONS

MODEL..................................................................................................
Displacement ............................................................................... cm
Power ........................................................................................... kW
Spark plug ...........................................................................................
Petrol : oil ratio ....................................................................................
Tank capacity ............................................................................. litres
Trimming length ........................................................................... mm
Operator ear noise pressure level (ISO 11201)
Measurement uncertainty (2006/42/EC - EN 27574)................. dB(A)
Measured acoustic output level (ISO 3744) ............................... dB(A)
Measurement uncertainty (2006/42/EC - EN 27574)................. dB(A)
Vibration level (EN 774 - EN 28662) ........................................... m/s
Measurement uncertainty (2006/42/EC - EN 12096) ................. m/s
Mass .............................................................................................. kg

10. ACCESSORIES

Only cutting tools with the following codes must
be used on this machine:
6990176 - Pair of blades (HTM 60)
6990181 - Upper blade (HTM 75)
6990182 - Lower frame (HTM 75)
Given the product evolution, the above men-
LIKELY CAUSE
– Incorrect starting procedure
– Dirty spark plug or incorrect distance
between the electrodes
– Air filter clogged
– Carburation problems
– Air filter clogged
– Carburation problems
– Dirty spark plug or incorrect
distance between the electrodes
– Carburation problems
– Incorrect composition
of the fuel mix
– Carburation problems
SOLUTION
– Follow the instructions
(see chap. 5)
– Check the spark plug
(see chap. 7)
– Clean and/or replace the filter
(see chap. 7)
– Contact your Retailer
– Clean and/or replace the filter
(see chap. 7)
– Contact your Retailer
– Check the spark plug
(see chap. 7)
– Contact your Retailer
– Prepare the fuel mix according to
the instructions (see chap. 4)
– Contact your Retailer
3
....................... dB(A)
2
2
tioned tools may be replaced in time by others,
with similar interchangeable and operating safe-
ty characteristics.
HTM 60 HTM 75
25.4
0.8
NGK BPMR6Y NGK BPMR6Y
50 : 1
0.5
550
90,5
1,4
105
1,6
5,4
1,1
5.7
25.4
0.8
50 : 1
0.5
700
91
1,3
105
1,6
7,4
1
5.4