Technical Assistance - S&P GET-60 NF PLUS Instrucciones De Montaje

ned at least every two months,
according to the following instruc-
tions:
- Remove the filters from the hood
and wash them with a solution of
water and neutral liquid detergent
and leave the dirt to soften.
- Rinse with plenty of warm water
and leave to dry.
- The filters can also be washed in
the dishwasher.
- After a few washes, you may find
that the colour of the aluminium
filter panels has been altered. This
shall not give rise to claims for
replacement of same.
- The active carbon filters are not
washable and cannot be reused;
they must be replaced at least
every four months. Saturation of
the active carbon depends on the
use made of the hood, the kind of
cooking and how often the exter-
nal grease-proof filter is cleaned.
- Clean grease remains frequently
from the fan and all the surfaces,
using a cloth moistened with ethyl
alcohol or neutral, non-abrasive
liquid detergents.
- To replace the halogen bulbs
(Fig. 8), carefully remove the inner
ring (G), which is pressed in, and
the round glass (F). Remove the
bulb (H) in the direction indicated
by the arrow and change it for one
of the same kind and characteris-
tics (12V - 20W). Remember not
to touch the bulb directly with
your fingers as this may decrease
its life.

4. TECHNICAL ASSISTANCE

The widespread S&P technical
assistance network guarantees
good technical service.
Should you observe any fault on
your device, please contact any of
the official services mentioned and
you will receive appropriate atten-
tion.
Any handling of this device by peo-
ple other than Official S&P person-
nel will lead us to cancel your gua-
rantee.
S&P RESERVES THE RIGHT TO
MODIFY THE PRODUCT WITHOUT
PRIOR NOTICE.
S&P SHALL NOT BE HELD RES-
PONSIBLE FOR ANY DAMAGE
CAUSED BY FAILURE TO COMPLY
WITH THESE WARNINGS.
11