Temperature And Humidity - König Electronic KN-WS500 Manual De Uso

Temperature and Humidity:

1. Temperature range indoors: 0ºC -50ºC (32ºF -122ºF) Temperature range outdoors: -50ºC -70ºC
(-58ºF-158ºF).
2. Range of humidity: 20%-99%.
3. Tendency of temperature change: one check per hour, compared to previous data. If the
temperature changes more than 1 ºC the arrow will be flat.
RCC Reception Mode:
1. RCC reception format: DCF, the reception time is about 10 minutes.
2. RCC reception way.
3. It will begin to receive the RCC 3 minutes after turning on the unit.
4. RCC reception graphic:
The tower graphic flashes when receiving, the tower graphic will also flash when lost or no signal. The
tower graphic will not flash when synchronizing the signal, but the arc-shaped antenna symbol on top
of the tower graphic is flashing. The whole RCC reception graphic will display when the reception is
successful: The tower graphic will turn off and exit RCC when the signal reception fails.
Part II
There are 7 buttons at the rear: LIGHT CHANNEL RESET DOWN UP ALARM/SET TIME/SET. These
buttons are used for the following functions:
1. LIGHT button
* In normal display mode press this button, the LED will light up.
2. Press CH button to select between channel 1, 2, and 3 when receiving a signal from transmission.
Please note that the selected channel must comply with the channel set for transmission, e.g. if the
transmission is set to channel 1, then the station needs to be set to channel 1 as well.
3. UP Button (at the rear)
* The function for this button is the same as the 12/24 on the front; it can toggle between 12/24-hour
formats.
4. DOWN Button (at the rear)
* In normal display mode press this button to toggle between degrees Celsius or Fahrenheit.
5. Alarm/Set Button
* Press ALARM button at the rear to display the alarm time.
* To set the alarm time, press ALARM once, the alarm time displays. Press and hold the button for
3 seconds, the alarm HOUR digit flashes, use UP or DOWN to set the alarm hour.
* Press the ALARM button again, the alarm MINUTE digit flashes, use UP or DOWN to set the alarm
minutes. Then press ALARM again to finish the alarm setting.
* The alarm icon will display after finishing the alarm setting. Press ALARM/SET again to turn off the
alarm icon.
6. TIME/SET Button
* Press TIME/SET button and hold for 3 seconds when beep sounds, YEAR digit flashes. Use UP or
DOWN button at the rear to set the YEAR.
* Press TIME/SET again twice, the MONTH digit flashes, use UP or DOWN at the rear to set the
MONTH
* Press TIME/SET button again , the DATE digit flashes, use UP or DOWN at the rear to set the
DATE
3