König Electronic KN-WS500 Manual De Uso página 4

* Press TIME/SET button again twice , the HOUR digit flashes, use UP or DOWN at the rear to set
the HOUR
* Press TIME/SET button again, the MINUTE digit flashes, use UP or DOWN at the rear to set the
MINUTE
* Press TIME/SET again twice to resume normal display mode
7. RESET
Press this button to reset all function.
Part III
Use the Transmitter:
* For each weather station there is a transmitter. Set the channel after inserting the battery at the rear
of the transmitter. There are 3 settings: channel 1, 2 and 3.
* The maximum distance between the station and the transmitter is 20 m in open areas. Greater
distance or buildings in-between station and transmitter will affect signal transmission and
reception.
* Transmitter shall be kept away from rain or water.
Part IV
Points to note:
* Tolerance:
• The tolerance for temperature variation is +/- 2 ºC.
• The tolerance for humidity variation is +/- 5%.
Remarks:
1. 3x AAA batteries or DC 4.5V adapter are needed to operate the weather station.
2. 2x AAA batteries are needed to operate the transmitter.
3. The transmitter distance is 30m.
4. Transmits one time every second. The light will flash at the same time.
5. Select the channel and change the temperature unit inside the battery compartment.
6. When the RCC signals flashing, the handset function is turn off. Press the DOWN once to stop the
RCC signal flashing; it will recover the handset function.
7. The system's channel is CHANNEL1.
Safety precautions:
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
from mains and other equipment if a problem should occur. Do not expose the product to water or
moisture.
Maintenance:
Clean only with a dry cloth. Do not use cleaning solvents or abrasives.
Warranty:
No guarantee or liability can be accepted for any changes and modifications of the product or damage
caused due to incorrect use of this product.
General:
Designs and specifications are subject to change without notice.
To reduce risk of electric shock, this product should ONLY be opened by
an authorized technician when service is required. Disconnect the product
4