Publicidad
Idiomas disponibles
Idiomas disponibles
RAC 83/95
TOOL IDENTIFICATION
The riveting tool RAC 83/95 is identified by a label showing the name
and the address of the manufacturer and model. If any service is
requested please make reference to data shown on the label.
Model
RAC 83/95
GENERAL NOTES AND USE
The tool must be used for rivets diam. 2,4 -4,8 mm only.
Diam 4,8 mm only in aluminium.
TECHNICAL DATA
• Working preessure ........................................................ 6 BAR
• Min. int. diam. of the compressed air
feeding hose .............................................. min. diam= 8 mm
• Air consumption per cycle ..............................................1,6 Lt.
• Max power .........................................................6 BAR 535 Kg
• Weight ........................................................................... 1,4 Kg
• TWorking temperature ............................................- 5° / + 50°
• Root mean square in total acceleration frequency (Ac)
to which the arms are subjected.............................3,3 m/sec2
AIR FEED
The air feed must be free from foreign bodies and humidity in order
to protect the tool from premature wear and tear of the components
in movement, therefore we suggest to use a lubrificator group for
compressed air.
MAINTENACE AND CHANGE OF SIZE (fig. f1)
The extended utilization of the riveting tool can cause the slipping
of the clamps on the nail due to the deposited impurities. For this
reason, it is necessary to lubricate the clamps after having cleaned
them . However, if clamps are worn out and as a consequence their
working is jeopardized, replace them.
First remove the head which carries the nozzle (E), by means of a
standard spanner of 27 mm. Then, by using two standard spanners of 15
mm and 16 mm, remove the chuck (F) and extract the clamps (G).
When replacing the nozzle (A), we recommend to use a 12-mm standard
spanner and fit the removed nozzle in the proper housing located on the
bottom of your riveting tool, in order to avoid losing the nozzle.
Revision - 03
GB
Name and address of
manufacturer
Date 04-2008
WARNING!
Desconnect air feed when performing those
operations.
f1
27 mm
E
16 mm
G
12 mm
15 mm
F
A
7
Publicidad
