Installation And Connection - Trevi SB 8350TV Manual De Uso

ENGLISH SB 8350TV
NOTES ON USE
This is a precision electronic appliance; avoid using it in the following cases:
- Near strong heat sources, such as central heating plants or stoves.
- In very humid places such as bathrooms, swimming pools, etc.
- In very dusty places.
- In places subject to strong vibrations.
- Position the appliance in such a way that there is always enough room for free air circulation (at least 5 cm).
- Do not block the air inlets.
- If any liquid enters the appliance, unplug it immediately from the socket and take it to the nearest TREVI authorised service centre.
- Before switching on the appliance, always check that the power cable and the connection cable are properly installed.
CARE AND MAINTENANCE
Use a slightly damp soft cloth for cleaning. Do not use solvents and abrasive substances.
IMPORTANT
This appliance has been carefully built to ensure long-lasting perfect performance. However, should any inconvenience occur, please contact your
local authorised TREVI Service Centre.
TREVI follows a policy of ongoing research and development. Therefore products may have different features from those described.
DESCRIPTION OF CONNECTORS/CONTROLS
Controls and Connections on the Device
1. Active input selection key
2. Operation LED indicator / active input / standby
3. Volume adjusting keys (+ to increase the volume, - to decrease the volume)
4. Remote control receiver
5. LINE IN1 and LINE IN2 input jack 3.5 mm stereo
6. Power supply inlet AC220V
Remote control controls
1. ON/OFF key
2. Active input activation keys
3. Remote control operation led
4. LEARN key, activates the self-learning function
5. MUTE key, activates the MUTE function
6. Volume adjusting keys (+ to increase the volume, - to decrease the volume)
7. RSBASS key, activates/deactivates the RS Bass function
8. Keys that can be associated with the LEARN self-learning function to control the TV
REMOTE CONTROL BATTERY ACTIVATION AND REPLACEMENT
The remote control features a CR2025 battery.
To activate the remote control battery (supplied therein), remove the protective plastic tab.
To replace the battery:
1. Remove the battery compartment in the arrow direction (see the picture in rear case of remote control).
2. Replace the battery with one of the same type (CR2025).

INSTALLATION AND CONNECTION

The Sound Bar can be installed on a surface used as a support for the
television (max. 50 kg) or on the wall.
Use a 3.5 mm jack cable to connect the LIN IN1 and LINE IN2 (5) inlet to the
phone/audio outlet of any device (TV,dvd, computer, multimedia player...).
5