Trevi SB 8350TV Manual De Uso página 6

ENGLISH
CONNECTING TO THE POWER SUPPLY
Fit the plug into an AC 220V - 50Hz socket. Do not plug the appliance to different power.
Unless otherwise specified, the controls description applies to both the appliance and the remote control.
POWER ON/ STANDBY AND AUTO POWER FUNCTION
1. Press the power-on/standby ON/OFF key (1) to switch on the device.
2. Press the power-on/standby ON/OFF key (1) again to switch the device back to standby mode.
This device is equipped with an AutoPower On/Off function that automatically turns on the Sound Bar when it detects an
audio signal on one of the inputs and automatically turns it off if no input signal is detected for more than one minute.
Note: If the Sound Bar does not react to any operation or does not work properly, disconnect the power cable
for 30 seconds to reset the device.
VOLUME CONTROL AND MUTE FUNCTION
Volume can be adjusted using the volume control keys (3 on the device, 6 on the remote control)
1. Press the + key to increase the volume of the device.
2. Press the - button to decrease the volume.
Note:
If the device is connected to the phone outlet of a TV or of a device equipped with speakers, these are usually deactivated. To achieve a good
output signal, adjust the volume to the maximum using the TV controls (or the controls of the device).
If the Sound Bar is connected to the audio-scart output of a TV (or any other audio output different from the phone output of another device)
the audio output level is steady and cannot be adjusted using the TV controls (or the device controls). The speakers of the TV (or of the device)
are not deactivated and to mute them it is necessary to lower the volume completely. Otherwise, the speakers can be adjusted to playback
the audio signal together with the Sound Bar.
MUTE function: Use the MUTE key (5) on the remote control to activate the audio off function. To activate the audio again press the MUTE key again.
Warning:
- Some audio output to which the Sound Bar may be connected (such as the phone output) might have their own volume controls. Make
sure that the audio output level is properly adjusted on the source device otherwise the output volume of the Sound Bar, even if set to the
maximum, will be low.
- If during the playback the sound coming from the Sound Bar is distorted, this means that the input signal is too high. Lower the volume of
the Sound Bar or lower the audio output level on the source device.
- If the Sound Bar is connected to a TV through the phone output, it might happen that the sound is low even if the volume is set to the maxi-
mum. In this case, try to connect the Sound Bar to the audio-scart output using the supplied adapter.
To the LINE IN
input (5) of the
Sound Bar
RS BASS FUNCTION
The RS BASS function allows to change the sound dynamics of the Sound Bar giving the impression of a full all-round entertainment.
1. Press the RS-BASS key (7) on the remote control to activate the RS Bass function.
2. Press the RS-BASS key (7) on the remote control again to deactivate the RS Bass function.
REMOTE CONTROL SELF-LEARNING FUNCTION
This function allows to use only one remote control to control both the Sound Bar and the device to which it is connected, usually a TV. The remote
control is able to self-learn and store up to 7 controls to control the basic functions of other devices.
The self-learning key have been associated with the names of the most common functions of a standard TV to make this operation easier for the
user: TV CH (change channel), TV VOL (volume adjustment), ON/OFF key, input selection key, ENTER key (confirmation). Anyway, it is possible to
associate these keys with any function available on the remote control of any device.
To the phone
output of the TV
To the scart output of the TV using
the appropriate Scart Tv Audio
Out adapter
6
SB 8350TV