Philips 150P3A Manual De Usuario página 46

Regulatory Information
Energy Star Declaration
This monitor is equipped with a function for saving energy which supports the VESA Display Power
Management Signaling (DPMS) standard. This means that the monitor must be connected to a
computer which supports VESA DPMS to fulfill the requirements in the NUTEK specification 803299/94.
Time settings are adjusted from the system unit by software. From indicated inactivity to Power Saving
Position A2, the total time must not be set to more than 70 minutes.
NUTEK
Normal operation
Power Saving
Position A1
Power Saving
Position A2
A E
s an NERGY
E
the NERGY
We recommend you switch off the monitor when it is not in use for quite a long time.
Federal Communications Commission (FCC) Notice (U.S. Only)
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
Use only RF shielded cable that was supplied with the monitor when connecting this monitor to a computer device.
To prevent damage which may result in fire or shock hazard, do not expose this appliance to rain or excessive moisture.
THIS CLASS B DIGITAL APPARATUS MEETS ALL REQUIREMENTS OF THE CANADIAN INTERFERENCE-CAUSING EQUIPMENT
REGULATIONS.
file:///D|/03771/espanol/150p3ac/SAFETY/regs/regulat.htm (5 of 10) [6/24/2002 2:25:50 PM]
VESA State LED Indicator
ON Green
Suspend Amber
OFF Amber
®
S P PHILIPS
TAR artner,
®
S
TAR guidelines for energy efficiency.
RETURN TO TOP OF THE PAGE
PHILIPS
150P3A
150P3C
Power Consumption
< 30 W
< 2 W
< 2W
has determined that this product meets