Electrical Connections - Vortice VORT HR 350 AVEL Manual De Instrucciones

ENGLISH
IMPORTANT:
Fig. 4
- Winter operating:
- Summer operating:
Fig. 5
The siphon must be created observing indicated dimensions, otherwise correct operation of the appliance cannot be
guaranteed.
NOTE
We recommend to cut obliquely the end of the hose.
Condensate can also be drained off through the waste plumbing system of the building.
Accessibility
Fig. 35-36
In case of Ordinary Maintenance, you can Replace filters removing filters closing caps from the front panel (see:
"Maintenance and cleaning").
Fig. 11-12
Otherwise, the product is easly accessible removing the front panel. Front panel removing have to be performed:
- During produtc installation:
- Extraordinary Maintenance:

Electrical connections

Equipment must be powered by means of an external electrical mains. Installation of the electrical system can be carried
out with:
- a trace system (built-in);
- or, surface mounted by means of an external wall channel.
CAUTION!:
After completing electric connections, all terminal blocks and cable connections have to be accessible
!
using tool only. So, the User can not open the wiring box with hands, but User need to use a screwdriver
or other tool. To ensure this, we advise to fix the wiring box cap using screws. If tool is necessary to access
to wiring box, other solutions could be performed.
CAUTION!:
!
Equipment connection must be carried out by professionally qualified personnel.
CAUTION!:
!
The electrical power line to which the equipment will be connected must be protected by a suitable
differential thermal magnetic switch.
Fig. 28
Electric connections are easly available thanks to external cables, sited on the product back.
Available electric connections:
- Main supply
- Remote control
- Pre-heater
- Environmental sensors:
- C HCS
- C TEMP
- C SMOKE
- C PIR
- C TIMER
For more details to connect the Remote control, see the Remote control Instruction booklet supplied with the Remote
control: paragraph "Electrical connections".
high probability of condensate forming; drain hoses must be connected, with a
siphon trap. "a".
probability of condensate forming; drain hoses should be connected, with
a siphon trap. "b".
see "Expected mountings";
for technical personnel, you must call the Service.
Cod. 12.994 Humidity sensor;
Cod. 12.992 Temperature sensor;
Cod. 12.993 Smoke sensor;
Cod. 12.998 Passive infrared sensor;
Cod. 12.999 Adjustable over-run timer;
Fig. 29
Fig. 30;
Fig. 31;
Fig. 32;
Fig. 33;
Fig. 33;
Fig. 33;
Fig. 34.
27