Chauvet DJ Funfetti Shot Guía De Referencia Rápida página 5

Funfetti Shot QRG
Mounting
Mounting Diagram
AC Power
Fuse Replacement 1.
Before mounting this product, read the
level surface using the double brackets provided or use a clamp to mount to
truss systems (such as TRUSST®). Always use at least one safety cable to
secure to rigging.
Ensure that the launcher is not shooting directly into anyone's face or
above heavy traffic areas.
Safety Cable
(such as CH-05
from Chauvet)
Overhead Mounting
When mounting overhead, be sure to point Funfetti Shot™ at an upward
angle to keep the confetti from pouring out prior to launching.
This product has a voltage-specific power supply that can work with an input
voltage of 120 VAC, 60 Hz or 230 VAC, 50 Hz.
To eliminate unnecessary wear and improve its lifespan, during periods
of non-use completely disconnect the product via breaker or by
unplugging it.
Disconnect the product from power.
2. Wedge the tip of a flat-head screwdriver into the slot of the fuse holder.
3. Pry the safety cap out of the housing.
Remove the blown fuse from the clip on the front of the safety cap and
4.
replace with a fuse of the exact same type and rating.
5. Re-insert the fuse holder and reconnect power.
Disconnect the product from power before replacing the fuse.
Safety
Mounting Clamp
(such as the CLP-15N
clamp from Chauvet)
5
Notes. Place launcher on a flat,
Floor Mounting
EN