Maintenance And Storage - Ribimex Ribitech PRTRM1000 Manual De Instrucciones

5.5- Pulling capacity
1. The winch has a capacity of 540 kg (T12) or 1080 Kg (T25). Applying this measurement to
practical applications, the winch can be used to pull the following:
(R) Rolling load
(M) Marine load
(T) Pulling load
(Traction)
2. The pulling capacity reduces as the incline increases.
For example, the rolling capacity for model T12 is reduced from 540 kg on flat ground to 90 kg on a
45° incline.
Please refer to the following chart for estimated pulling capacity (rolling weight) on various inclines.
Maximum rolling weight capacities on an incline, where: P = Weight and I = incline degree
T12
VI. MAINTENANCE AND STORAGE
6.1- Winch maintenance
1. Follow the instructions for lubricating periodically
Lubricate the cable and hook regularly with slight grease.
Grease the gears every 6 months. Use any good quality waterproof grease.
2. Inspect periodically all parts, steel cable, accessories and replace them if damaged or used.
3. Have damaged parts replaced by an authorized service center.
4. Check the nuts periodically and tighten them if they are loose.
6.2- Storage
Product must be stored in a dry location. Always lock up product and keep out of reach of children
- a wheeled moving vehicle of up to 540 kg (T12) or 1100Kg (T25)
- a water borne craft of up to 450 kg (T12) or 1000Kg (T25).
- a load of up to 180kg (T12) or 360Kg (T25) from a dead stop on level
ground.
T25