AL-KO 351-1201 Plus Manual De Instrucciones página 13

Assembly
Type 501 Plus, 901 Plus, 1201 Plus - automatic
rolling mechanism
1. Pull out the safety button (4-1).
2. Push the crank handle onto the drive shaft
(4-2).
The safety button should automatically
click into place.
Installing the rope
ADVICE
When under load, the rope must be
wound at least two turns onto the drum.
Mark the rope run-out with colouring.
Type 351 Plus
1. Feed the steel rope through the long hole of
the drum from the inside (7).
2. Insert the end of the rope into the clamp in a
large loop and gently tighten hexagon nut (8).
3. Pull the loop back up to the clamp and tigh-
ten the hexagon nut with a tightening torque
of max. 10 Nm.
4. Wind the rope in two full turns.
Do so by turning the crank handle in the
"Lift" direction.
5. Mark the rope run-out in colour (6-2).
Type 501 Plus, 901 Plus D, 901 Plus
1. Insert the steel cable from the inside to the
outside through the slot in the cable drum
(9-1).
2. Insert the end of the cable through the embos-
sed cable clamp.
Let the end of the cable project by at least
10 mm (9-2).
3. Tighten the nuts of the cable clamp firmly (M5
= 6 Nm; M6 = 10 Nm).
4. Wind the rope in two full turns.
Do so by turning the crank handle in the
"Lift" direction.
5. Mark the rope run-out in colour (6-2).
Type 1201 Plus
1. Feed the steel rope through the long hole of
the drum from the inside (10-1).
2. Insert the steel rope into the clamping piece
on the rope drum.
3. Clamp the steel rope using the two Allen
screws (10-2).
4. Wind the rope in two full turns.
Do so by turning the crank handle in the
"Lift" direction.
5. Mark the rope run-out in colour (6-2).
352 921_c
Installing an optional strap
Our winches can optionally be used with a special
loop strap instead of a rope.
CAUTION!
Risk of accident!
The breaking force of the stitched strap
must be at least 7 times the specified ten-
sile force in the lowest cable position.
ADVICE
The following must be observed during
strap installation: – always turn the crank
handle in the "LIFT" direction!
Installing the strap
Typ 351 Plus, 501 Plus, 901 Plus, 901 Plus D
1. Feed the AL-KO connector through the strap
loop (11-1).
2. Secure with a split pin (11-2).
3. Wind the strap in two full turns and mark the
strap run-out in colour.
Typ 1201 Plus
1. Feed the AL-KO connector through the strap
loop (12-1).
2. Secure this with a bolt and a hexagonal nut
(12-2, 13).
3. Wind the strap in two full turns and mark the
strap run-out in colour.
Fastening the winch
Typ Plus
351
501
901 Plus D
901
Fastening Torque
material
3 hex.
head
screws M8
8.8
25 Nm
3 was-
hers8 DIN
125A
3 hex.
head
screws
M10 8.8
49 Nm
3 was-
hers10
DIN 125A
13