Korg monotribe Manual De Usuario página 15

Pitch
FLUX ON
FLUX OFF
Step 1 Step 2
7. REC button
Pressing this button during playback will put the monotribe in record
mode; the REC LED will light-up. When you play the ribbon key-
board, the data of your performance will be recorded.
Pressing this button while stopped will put the monotribe in recor-
dready mode; the REC LED will blink. In this state, pressing the PLAY
button to start playback will activate record mode.
To exit record mode or record-ready mode, press the REC button once
again to make the REC LED go dark.
8. GATE TIME button
By holding down this button and using the ribbon keyboard while
a sequence plays back, you can change the gate time (duration) of the
synth part's notes; the change in gate time corresponds to the posi-
tion where you touch the ribbon keyboard.
The gate time will be the minimum value (1.4%) at the far left of the
ribbon keyboard, and the maximum value (100%) at the far right. By
performing this operation in REC mode, the gate time for each step
can be recorded in the sequence to occur during playback.
Note-on
1.4%
Step 1
Step 3 Step 4 Step 5
50% 100%
Step 2 Step 3
9. STEP LEDs
These LEDs will light-up or go dark when you press the correspond-
ing step button. While a sequence plays back, the LEDs will blink to
indicate the current step.
10. STEP buttons
These buttons turn each step on/off.
ON The step will be played and its step LED will light-up.
OFF The step will not be played and its step LED will
not light-up.
If you record on a step that is turned off, it will automatically turn
on. If you do this, any data previously recorded in that step will be
erased.
Drum sound generator sequence controls
11. RHYTHM knob
This knob adjusts the volume of the drum sound generator.
12. STEP buttons
These buttons turn each step of the selected drum part (BD, SN, HH)
on/off.
The step will be played and its step LED will light-up.
ON
The step will not be played and its step LED will
OFF
not light-up.
If you turn on a step button while holding down a part button, the
part will sound half way through the step. This applies to each of the
8 step buttons, effectively providing 16 steps for the rhythm sequence.
Step
Part button
released
held down
Owner's manual
15