Back Panel Features - Harman Crown XTi2 Serie Operación Manual

XTi2 Series Power Amplifiers

Back Panel Features

XTi 1002, 2002, 4002
Power Cord Clip:
Mounting points for
securing, included
power cord clip.
AC Power
Connector
XTi 6002
Power Cord Clip:
Mounting points for securing,
included power cord clip.
AC Power
Connector
Circuit Breaker:
Provides overload protection
Operation Manual
Binding Post Output Jacks:
One pair per channel, accepts banana plugs or
bare wire. Note: Binding Post outputs on European
models come with safety plugs installed to prevent
European power plugs from being inserted. The
side entry positions for these connectors should
be used with European models.
4-Pole Speakon ® Output Connectors:
These two connectors accept 2-pole and 4-pole
Speakon© connectors. The channel 1 connector is
wired for both channels so it can be used for
bridge-mono wiring or stereo wiring of two
speakers to a single Speakon.
Binding Post Output Jacks:
One pair per channel, accepts banana plugs or
bare wire. Note: Binding Post outputs on European
models come with safety plugs installed to prevent
European power plugs from being inserted. The
side entry positions for these connectors should
be used with European models.
4-Pole Speakon
These two connectors accept 2-pole and 4-pole
Speakon© connectors. The channel 1 connector is
wired for both channels so it can be used for
bridge-mono wiring or stereo wiring of two
speakers to a single Speakon.
Fans:
Provide front to back
forced airflow for cooling.
Fans:
Provide front to back
forced airflow for cooling.
® Output Connectors:
Input Connector:
Two 3-pin XLR input
connectors are provided
(one per channel).
Link/Out Connector: HiQnet USB Connector:
Two 3-pin XLR output Type B USB connector allows
connectors are provided you to connect the amplifier to
(one per channel) to a computer for use with
loop-thru signal from one System Architect
amplifier to another. Manager
Input Connector:
Two 3-pin XLR input
connectors are provided
(one per channel).
Link/Out Connector: HiQnet USB Connector:
Two 3-pin XLR output Type B USB connector allows
connectors are provided you to connect the amplifier to
(one per channel) to a computer for use with
loop-thru signal from one System Architect
amplifier to another. Manager
and Band
™
software.
™
and Band
™
software.
™
page 9