Regulatory Information - Robot Roomba e6 Guia Del Usuario

Regulatory Information

This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This device complies with Industry Canada license-exempt RSS
standard(s). Operation is subject to the following two conditions: 1)
This device may not cause interference, and 2) this device must accept
any interference, including interference that may cause undesired
operation of the device.
• Changes or modifications not expressly approved by iRobot
Corporation could void the user's authority to operate the
equipment.
• This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules
as well as ICES-003 Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio commu-
nications. However, there is no guarantee that interference to radio
communication will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
©2018 iRobot Corporation, 8 Crosby Drive, Bedford, MA 01730 USA. All rights reserved.
iRobot, Roomba, iAdapt, Home Base and Virtual Wall are registered trademarks of iRobot
Corporation. Dirt Detect is a trademark of iRobot Corporation. App Store is a trademark of
Apple, Inc., registered in the U.S. and other countries. Google Play is a trademark of Google, Inc.
WC: 4632505
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
• Under Industry Canada regulations, this radio transmitter may only
operate using an antenna of a type and maximum (or lesser) gain
approved for the transmitter by Industry Canada. To reduce
potential radio interference to other users, the antenna type and
its gain should be so chosen that the equivalent isotropically
radiated power (e.i.r.p.) is not more than the necessary for
successful communication.
• FCC Radiation Exposure Statement: This product complies with
FCC §2.1093(b) for portable RF exposure limits, set forth for an
uncontrolled environment and is safe for the intended operation as
described in this manual.
• ISED Radiation Exposure Statement: This product complies with the
Canadian Standard RSS-102 for portable RF exposure limits, set
forth for an uncontrolled environment and is safe for the intended
operation as described in this manual.
For battery recycling go to call2recycle.org;
or call 1-800-822-8837