Stile CF0110 Guia De Instalacion página 15

INSTALLATION
NOTICE:
The decorative arms in the next two steps are not
required for fan operation. You may skip these two
steps if you do not wish to install the decorative
arms.
 Install the decorative arms using a Phillips head screw-
driver. Attach one side of each arm to the center arm
support using the Phillips cap screws and screw covers
as shown.
NOTE: For easier assembly, insert each screw and par-
tially tighten, then go back and fully tighten each screw.
 Finish the assembly by screwing the finial screw on each
DECORATIVE ARM
CAP
SCREWS
SCREW
COVERS
 Restore power to the room and wall switch. Turn on the
DECORATIVE ARM
15 - English
arm into the threaded holes in the top lens cover.
FINIAL
SCREW
wall switch, then refer to the remote control operating
instructions in the next section to test the fan's operation.