System Interface - Audiolab LIVE 24 XL Manual De Usuario

POST, and the background will illuminate. The
selected channel will derive its signals from all
channels post-fader. If the button has not been
pressed and not illuminate, by default, the select-
ed channel will derive its signal from all channels
pre-fader and all unaffected by the sending chan-
nel's fader position.
This icon is a switch to change all
channels to be POST or PRE. If the
selected channel was linked, they will change
synchronous in this page when you adjust
them.
Slide the fader or rotate Parameter Adjust
knob to adjust level of selected input channel.

System interface

Text in these box show current
corresponding preset you have
saved.
Touch these icons to enter
corresponding page.
You can use this fader
to adjust the LCD bright-
ness.
It is the same as PFL on the panel, touch it
and it will be illuminated in synchronization
with the PFL button on the pan-
el. For details, please refer to the
introduction of the PFL in the panel
section.
Select the default interface is Full
Mixer or Mixer after restarting the
mixer.
Touch this button to change pass-
word of the system. Input an old
password and a new password. The
system will save the new one as current pass-
word. Please note messages on the screen when
operation.
Touch this button to lock the sys-
tem. Once locked, you must input
your password to unlock it. Default
password and Super password is "2412", which
means you can tap it to unlock your mixer every
time you forget your password. Please note mes-
sages on the screen when operation.
At the lower right corner,
you can see instruction of
the DSP firmware.
Load/Save interface
In this interface you can load or save Scene, Ef-
fect, GEQ or DSP channel setting too. The chosen
preset can be deleted by pressing Delete. Please
notice the instruction that is shown on the LCD
display.
P. 29
- AUDIOLAB Live 24 XL
English version