Safety Instructions; Technical Specifications - BasicXL BXL-STRSCOOP10 Manual De Uso

MINI STROBOSCOPE

SAFETY INSTRUCTIONS

• Do not operate the BXL-STRSCOOP10 without a front or with a broken panel.
• If the device has been exposed to excessive temperature fluctuations, do not switch on
immediately. Arising water condensation might damage your device. Leave the
BXL-STRSCOOP10 switched off until it has reached room temperature.
• For indoor use only. Keep the item away from moisture & water.
• Do not open the device. There are no serviceable parts inside.
ATTENTION!
HEALTH HAZARD: Never look directly into the light source. Keep out of the reach of children.
INTRODUCTION:
Before initial start-up, make sure that there is no damage caused during transit. Pay particular attention
to the power cable and front panel for damage. If damage is found, please do not use the
BXL-STRSCOOP10. Contact your dealer.
OPERATIONS
* Unpack your BXL-STRSCOOP10.
* Connect it.
* The flash frequency can be adjusted by the controller at the rear panel.

TECHNICAL SPECIFICATIONS

Power supply:
Power consumption:
Dimensions:
Safety precautions:
Maintenance:
Clean only with a dry cloth. Do not use cleaning solvents or abrasives.
Warranty:
No guarantee or liability can be accepted for any changes and modifications of the product or damage
caused due to incorrect use of this product.
General:
Designs and specifications are subject to change without notice.
All logos brands and product names are trademarks or registered trademarks of their respective
holders and are hereby recognized as such.
Keep this manual and packaging for future reference.
Attention:
This product is marked with this symbol. It means that used electrical and electronic products
should not be mixed with general household waste. There is a separate collections system for
these products.
ENGLISH
230-240 V~, 50 Hz
14 W (max.)
140x 90 x 50 mm
To reduce risk of electric shock, this product should ONLY be
opened by an authorized technician when service is required.
Disconnect the product from mains and other equipment if a
problem should occur. Do not expose the product to water or
moisture.
2