HEINE EN 50 UNPLUGGED Instrucciones De Uso página 9

contact with electronic components. Before replacing the lid, remove
the protective cap from the three-pole battery contacts. Reattach
the lid with the eight screws, making sure that no wires are damaged
when doing so.
The battery should be disposed of correctly and should be completely
discharged before disposal.
Do not short-circuit the Li-Pol battery. This can occur when a
metal object such as a coin or paper clip connects the two battery
contacts together. This can damage the battery.
Service
The device has no components serviceable by the end-user.
General Notes
The warranty for the entire product is invalidated if non-genuine
HEINE products or non-original parts are used and if repairs or
modifications are made to the device by persons not authorized
by HEINE. For more information, please visit www.heine.com.
The expected life cycle, when the device is normal used and
the warning and safety information as well as the maintenance
instructions are observed, is up to 7 years. Beyond this period,
the product may continue to be used if it is in a safe and good
condition.
Use only an original HEINE plug-in transformer to connect the unit
to the local mains supply. Make sure that the local mains voltage is
the same as the nominal voltage shown on the identification plate
of the HEINE plug-in transformer.
Unplug the mains connector if you will not be using the unit for
a long period if you are cleaning it or if a fault occurs. An unlit
green power LED on the UNPLUGGED transformer and the EN50
UNPLUGGED does not guarantee a current free state.
Pay attention to the mounting instructions when wall-mounting
the EN50 UNPLUGGED charging station.
The capacity of the mPack UNPLUGGED Battery can reduce
with increasing use. This is a normal procedure with time and
inevitable. Careful use of the battery can reduce this effect. We
recommend that the instrument is use should be switched off
after use and the battery recharged regardless of its state of
charge.
The LED on the UNPLUGGED and EN50 UNPLUGGED transfor-
mers indicates the operational readiness of the power supply.
General Warnings
Check the correct operation of the device before use! Do not
use the device if there are visible signs of damage.
Do not use the device in fire- or explosive risk area (e.g. oxygen
saturated or anaesthetic environments)
The device is not allowed to be entered into strong magnetic
fields like MRI scanners.
Do not modify the device.
Use only original HEINE parts, spare parts, accessories and
power sources.
If the power source is transferred from a cold to a warm environ-
ment, let it rest for approximately 1 h to allow it to equilibrate to
the ambient conditions.
The device should never be used or stored outdoors, since this
may lead to malfunction.
Disposal
The product must be recycled as separated electrical and
electronic devices. Please observe the relevant state-specific
disposal regulations.
Dispose at your local collection point.
The appendix contains following tables
- Electromagnetic disturbances – Requirements and tests
- Technical specification
- Explanation of the used symbols
med 2014 2019-06-05
9/48