Foppapedretti Express Manual De Instrucciones página 20

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 45
• ENGLISH •
Gr. 1, from 9 to 18 kg (from 9 months to 4 years of age approximately)
Before installing the car seat in the vehicle, check that the car seat shoulder straps
are correctly adjusted to the child's height.
The straps can be adjusted to three different heights and must be passed through
the slots closest to the child's shoulders.
If the child's shoulders are at a height between two slots, always use the highest
position.
Make sure that the straps are not twisted and that they are correctly positioned
on the child's shoulders.
To adjust the height of the shoulder straps, remove the upper end of one shoulder
strap by rotating the metal stop device located on the back of the backrest (3),
then pass the end of the shoulder strap through the slots in the backrest shell and
the lining (4).
Reposition the end of the shoulder strap at the desired height using the same
slots, both in the lining and in the shell (5), and fasten it to the back of the backrest
again (6).
Check that the metal stop device is correctly positioned and that the end of the
shoulder strap is not twisted. Repeat this process with the other strap.
To tighten the straps: pull the free end of the left and right adjustment chest
strap; it is not necessary to press the buttons on the adjustment devices (7).
To loosen the straps: press the buttons on the adjustment devices located on the
upper ends of the shoulder straps and at the same time pull the lower part of the
shoulder straps (8). Press the red button on the shoulder strap buckle to open up
the belt and release the child.
Place the car seat against the rear passenger seat (9).
Lower down the headrest as far as possible. Pull the passenger seat belt so that
it is tight. Pass the two parts of the belt through the slots on the lining and the
backrest shell (10), making sure that the lap belt part passes under the armrest
of the car seat and that the diagonal part is in a vertical position between the
backrest and the headrest, without going through the belt guide located at the
bottom of the headrest.
Pass the passenger seat belt through the opposite slots from the back of the
headrest to the inside of the seat (11).
Check that the lap part of the passenger belt passes under the armrest and that
20

Publicidad

Tabla de contenido
loading

Tabla de contenido