►9.2.Leave the fan to cool for about 60 s,
en
in order to prevent internal damage due to
it
overheating (heater internal cooling).
►9.3.Take the "O/I" switch to position "O"
de
(Pic. 25).
es
►9.4.Disconnect the heater from the
fr
mains electricity (Pic. 26).
►9.5.Disconnect the heater from the gas
nl
supply pipe (Pic. 27-28-29).
pt
►►10. SWITCH-OFF FOR
da
ELECTRONIC MODELS (...E / ...ET)
fi
►10.1.Take the "O/I" switch to position
"O" (Pic. 25). The flame goes out and
no
the heater performs the post-ventilation
sv
phase. Wait for the cycle to be completed
pl
in order to prevent internal damage due
to overheating (the phase is automatic
ru
and can last 50 s÷5 min depending on
cs
the internal/external temperature at the
heater).
hu
►10.2.Close the gas cylinder (Pic. 24).
sl
►10.3.Disconnect the heater from the
mains electricity (Pic. 26).
tr
►10.4.Disconnect the heater from the
hr
gas supply pipe (Pic. 27-28-29).
lt
N.B.: Do not disconnect the heater from
the mains electricity, before the end of
lv
the post-ventilation phase, in order to
et
prevent internal damage due to over-
heating.
ro
sk
►►11. CLEANING AND
MAINTENANCE
bg
Have the after-sales assistance check
uk
correct functioning of the heater at least
bs
once a year and/or as required. The
appliance must be cleaned before it is put
el
away after use.
zh
►11.1.Before
maintenance, care and repairs of the
appliance,
carry
sequence [Par. 9. "SWITCH-OFF FOR
MANUAL MODELS (... / ...M / ...DV /
...M DV)" or "10. SWITCH-OFF FOR
ELECTRONIC MODELS (...E / ...ET)"].
starting
any
type
out
the
switch-off
►11.2.Cleaning only concerns the air
vent (rear side) of the heater.
►11.3.When the appliance is used
again, check the state of integrity of the
gas hose and power supply cable. If in
doubt regarding their integrity, request
the assistance of the technical after-sales
service.
►11.4.Do not carry out unauthorised
interventions.
►►12. ROOM THERMOSTAT
CONNECTION (...E / ...ET)
(optional)
Remove the plug connected to the
appliance and connect the room thermostat
(optional) (Pic. 30).
See wiring diagram (...E / ...ET).
of