Mannesmann 01802 Manual De Instrucciones página 4

Technical dates
max. capacity: 2000 kgs
lifting height: 135 - 342 mm
net weight: 9,2 kgs
Description
1. lifting plate
2. lever
3. carrying handle
4. pole-opening
5. lifting pole
6. release valve
7. steerable wheels
8. pressure valve
ATTENTION:
•
Use the Trolley Jack only for lifting your vehicle. Before starting any job on or below the vehicle, it
has to be secured by using adequate Jack Stands.
•
The Trolley Jack may be used for lifting vehicles upto 2 tons. Avoid overlaoding the Trolley Jack.
This might cause damages of the vehicle or Trolley Jack and increases the risk of accident or
injuries.
•
The Trolley Jack must be used on plane and solid surfaces. Before lifting the vehicle, it must be
secured against rolling.
•
Do not use the Trolley Jack for lifting, as long as any persons stay inside or lean agaist the
vehicle.
•
Under no circumstances the pressure-valve (8) at the side of the piston (covered by a
plastic-cap) has to be adjusted. This valve was adjusted in the factory and must not be
adjusted by the user.
Operation
1. For easy transport the handle has to be fastened by putting the holes over the hex-nuts of the
trolley housing.
2. In order to open and/or close the release-valve put the lifting pole over the valve, observing the
bolt in the pole fits the slot in the valve.
3. Before the first use under load, the release-valve has to be closed (by turning clockwise) and the
lever has to be lifted by moving the mounted pole up and down.
4. After the lever has reached its highest position, the release valve has to be opened carefully by
turning anti-clock-wise. During the lever moves down, move the pole 6 to 10 times up and down in
order to spread the oil in the Trolley Jack equally.
5. After closing the release-valve the Trolley Jack is prepared for use under load-condition.
6. Before starting to work, your vehicle has to be secured against moving by pulling the hand-brake
and by putting stop-wedges under the wheels.
7. Place the Trolley Jack under the vehicle, so that the lifting-plate will not damage any parts under
your vehicle (please refer to the manual of your vehicle to find the suitable places on the frame or
the chassis).
8. By moving the mounted handle of the Trolley Jack up and down, your vehicle will be lifted. Always
pay attention, that the vehicle and the Trolley Jack will not roll away.
9. After having lifted the vehicle to working-position it has to be secured by adequate Jack Stands,
before starting any job on or under the vehicle.
Never use the trolley as a jack stand!