Imetec R7609 Instrucciones De Uso página 19

DRYING IN THE TUMBLE DRYER
• The heated mattress cover can be dried in a tumble dryer on a delicate cycle at a
moderate temperature, but at the end of the drying cycle it must be air-dried to allow
it to dry completely.
• Remove the heated mattress cover from the tumble dryer at the end of the drying
cycle and reshape it to its original size.
• Allow the heated mattress cover to fully air-dry before using it again.
DRYING IN THE OPEN AIR
• When the heated mattress cover is spread out to dry on a clothes airer, it must be
stretched so the original size is more or less maintained. This is best done while the
heated mattress cover is still damp, working alternately on the opposite corners and
pulling one side at a time. You might have to repeat this procedure several times until
the heated mattress cover is completely dry.
WARNING! Spread out the appliance without using clothes
pegs to avoid damaging it, and leave it to fully dry spread out
on a drying rack that is not exposed to the sun.
• Only use the heated mattress cover when it's thoroughly dry.
• Do not iron the heated mattress cover.
WARNING! Examine the appliance against the light to make sure
the cables are not bent or twisted.
WARNING! If the appliance does not resume its original size or if
problems arise with the internal cables contact an authorised service
centre for a safety check.
STORING THE HEATED MATTRESS COVER
When not in use, store as follows:
• if the heated mattress cover has been washed, wait until it's completely dry;
• fold it like a normal blanket;
• you are advised to store the heated mattress cover in the original packaging it was supplied in;
• when storing the appliance, allow it to cool down before folding;
• put the heated mattress cover away in a dry place
Examine the appliance and its supply cord frequently for signs of wear or damage.
lf there are such signs or in the case of malfunction, contact an authorised technical
service centre.
EN
18