Using The Water Dispenser; Loading The Dispenser; Important; Child Safeguard - GE Profile GXCF25FBS Manual Del Propietário

Using the water dispenser.

Child
safeguard
4

Features and Parts List

Loading the Dispenser and Start Up
Sanitize the dispenser water tanks prior to
installing a full bottle of water for the first time
(see "Cleaning and Sanitizing the Water Tanks").
IMPORTANT: Make sure the dispenser is
unplugged with both the hot and cold power
switches (on the back of the dispenser) set to the
O (off) position. Before placing the water bottle on
the dispenser, wash hands and wipe the top of the
bottle with a clean cloth. Avoid touching the part
of the bottle that will be in contact with the water
dispenser.
Make sure the water level in the top of the
dispenser is low enough to allow for proper
bottle installation. Failure to do so may cause
the dispenser to overflow.
1. Peel the label from the top cover of the
bottle (if present). Do not remove the
entire bottle cap.

Child Safeguard

The HOT dispenser button is equipped with
a child safeguard that reduces the risk of hot
water being dispensed accidentally or by small
children. To dispense water, rotate the knob
counterclockwise and push the button in. The
knob will reset automatically when the button
is released.
Bottle Support Collar—Black (WS28X10048)
Separator (WS28X10013)
Cold Water Tank
Hot (Red) and Cold (Blue) Power Switch (back of dispenser).
The Cold (Blue) power switch also turns on the chiller
compartment.
Indicator Lights. The green light will be lit when the dispenser
is plugged in. The red and blue lights will cycle on and off
while the dispenser heats and cools the water. Compressor
start is delayed up to 3 minutes.
Hot , Room Temperature
Buttons
Dispenser Drip Tray (WS28X10031) and Grille (WS28X10032)
Compartment Drip Tray (WS29X10029)
Chiller Compartment. The compartment is intended solely for
use in chilling canned and boxed beverages and packaged
nonperishables.
Compartment Shelf (WS28X10028)
Drainage Cap (WS01X10008)
Silicon Stopper (WS01X10007)
2. Place the bottle on top of the dispenser
as shown, aligning the dispensing valve
probe to the center of the water bottle
cap. Press down until the probe
penetrates the bottle cap, allowing the
bottle to rest on the support collar.
3. IMPORTANT: Press both dispense buttons
until water runs from both taps.
4. Plug in the dispenser.
5. Set the COLD and HOT power switches
(located on the top left rear of the
dispenser) to the I (on) position.
6. Allow 30 minutes for water to reach hot
and cold temperatures.
Contact a local water bottle distributor to
purchase water bottles.
The dispenser heats water to a temperature of
approximately 190°F (88°C). Water temperatures
above 125°F (52°C) can cause severe burns or
death from scalding. Children, the disabled and
the elderly are at highest risk of being scalded.
CAUTION:
supervised by a parent when using this product.
, Cold Water Dispenser
Children should be