OK. OSF 400-M Manual De Instrucciones página 10

EN
10
Install the rear guard
with its handle facing up
to the motor unit using
the 4 screws.
1.
2.
13
Hook the front guard
onto the rear guard, ,
aligning both screw
holes.
OpERaTION
a
To adjust tilting angle,
loosen the screws.
Tighten again after
preferred adjustment.
10
11
Remove the rubber part
and turn the groove of
the motor shaft
upwards.
14
Install the screw and nut
to lock the guards.
Close the clips.
b
To switch the fan on,
select speeds I-III. To
switch fan off, select 0.
12
Slide the fan blade onto
the motor shaft, aligning
and tightening the
screw to the groove.
15
Plug in the appliance.
Unplug if it is not used
for some time.
c
Push the clutch knob to
activate swivel function.
Pull knob for normal
operation.