GALAGAR GALA 2000 MP Manual Técnico De Instrucciones página 20

3.2.2 INSTALLATION OF (FCAW) MIG/MAG SYSTEM WITHOUT GAS. TORCH TO NEGATIVE POLE.
MARK REF.
1 54312029
880015P
7.1
880025P
7.2
9 53112219
12 54312560
13 12140301221
3.2.3. MIG/MAG SYSTEM START-UP.
1) Make sure the mains voltage is 230 V.
2) Connect supply cable with the suitable plug to the relevant single-phase tap. See section 2.2.
3) Change the polarity if it is necessary. The torch must be to positive in MIG/MAG with gas process.
4) If the material to be welded is aluminium, change the flexible cable and the wire guide tube for the graphite cable
with the torch totally stretched.
5) Depending on the wire diameter, fit the groove of the suitable driving wheel to the work to be carried out.
6) Choose suitable gas to wire type to be welded. If it has a mobile workstation, check that the gas bottle is securely
held by the bottle-holder system. Above all check that the safety chain is perfectly fastened.
7) Install the pressure-reducing valve and connect gas hose checking that there are no leakages, throughout the
whole circuit.
8) Fit the wire reel into the support axle.
9) Fit the welding wire into the driving system. Do not force the wire pressure handle, as if this is too tight, the motor
remains on overload and does not reach the maximum speed, and if the handle is too slack, the wire could slip.
10) Once the wire has been fitted, we can then conect the MIG/MAG torch. The wire is loaded into the torch via the
wire purge pushbutton.
GALA 2000 MP
DESCRIPTION
Input cable
MIG Gala 1500 torch 4mts.
MIG Gala 2500 torch 4mts.
Earth clamp cable
Change of polarity cable
Wire reel 0,8-1,0
OBSERVATIONS
INCLUDED
CONNECTED TO POSITIVE
CONNECTED TO NEGATIVE
For tubular wire
20