Silca M-BOX Manual De Uso página 12

M-BOX
REGISTERING THE M BOX DEVICE
The M-BOX device must be registered in order to access the Silca Web services. This opera on can be
performed from any internet browser through the link
Remote Service program.
For details of the procedure see the instruc ons provided by the Silca Remote Service program.
ATTENTION: to register the product you need the M-BOX device ID (Silca serial number and Mac-
Address Wi-Fi). These can also be found on the labels located under the device.
M-BOX CONFIGURATION
To confi gure the M-BOX device you need to connect the device to a PC USB port using the USB cable provided
(type A/Micro B). On its website www.Silca.biz Silca provides a Windows program called Silca Remote Service
or SRS to guide the operator through confi gura on.
The installa on program for Silca Remote Service can be downloaded from the following link:
h p://www.silca.biz/media/1035614/v8/File/srs.zip
or www.Silca.biz . Follow the path described below:
"Products-> Silca Key Programs -> SKP Modules-> Silca Remote Service"
NOTE:
All details of the stages for M-BOX configuration are given in the on-line instructions provided by
the Silca Remote Service program.
CONNECTING M BOX TO THE INTERNET
The M-BOX device can be used only with an internet connec on.
There are two ways to connect to the internet (cabled LAN network; Wi-Fi Wireless network).
Both can be confi gured and enabled, but remember that fi rst choice for the device is always a cabled LAN
connec on.
CONNECTING TO A LAN NETWORK CABLED NETWORK
The M-BOX device can be connected to its local network by connec ng a standard LAN cable (Ethernet/Cat 5)
to the LAN port located on the back of the M-BOX.
( Fig.10 )
M-BOX is confi gured by default to automa cally obtain an IP address from the network through the Dynamic
Host Confi gura on Protocol (DHCP). For advanced network se ngs (fi xed IP address, subnet mask, gateway,
etc.) see the Silca Remote Service program.
CONNECTING TO THE WI FI NETWORK WIRELESS
The M-BOX device can be connected to its WIRELESS network by specially confi guring the SSID and password
of a chosen Hot Spot (router or Wi-Fi modem or mobile tethering device). Use the guided procedure described
in the Silca Remote Service program.
Wi -Fi connected M-BOX is confi gured by default to automa cally obtain an IP address from the Wi-Fi network
through the Dynamic Host Confi gura on Protocol (DHCP). For advanced network se ngs (fi xed IP address,
subnet mask, gateway, etc.) see the Silca Remote Service program.
12
OPERATING GUIDE
h ps:\\www.silcawebsw.com
Copyright Silca S.p.A 2016 - Vers.1
English
or by means of the Silca