Failure Display And Inspection - Candy CFIB6340RC Manual De Instrucciones

The induction hob or a
cooking zone has
turned itself off
unexpectedly, a tone
sounds and an error
code is displayed
(typically alternating
with one or two digits
in the cooking timer
display).
Never attempt to disassemble the unit by yourself.

Failure Display and Inspection

If an abnormality comes up, the induction hob will enter the protective state
automatically and display corresponding protective codes:
Problem
F1-F6
F9-FA
FC
E1/E2
E3/E4
E5
If there are anyone zone of the flexible area to be protected, the flexible area
selection control will not be able to use。
The above are the judgment and inspection of common failures.
Please do not disassemble the unit by yourself to avoid any dangers and damages
to the induction hob.
Technical fault.
Possible causes
Temperature sensor failure
Temperature sensor of the IGBT
failure.
The connection between the
display board and the main
board has failed
Abnormal supply voltage
Temperature sensor of the
ceramic glass plate is high
Temperature sensor of the IGBT
Is high
Please note down the error
letters and numbers, switch
the power to the induction hob
off at the wall, and contact a
qualified technician.
What to do
Please contact the supplier.
Please contact the supplier.
Please contact the supplier.
Please inspect whether power
supply is normal.
Power on after the power
supply is normal.
Please restart after the
induction hob cools down.
Please restart after the
induction hob cools down.
EN-27