Sony SDM-V72W Manual De Instrucciones página 36

Symptom
No picture
If the Power LED indicator is not
lit, or if the Power LED indicator
will not light up when the Power
button is pressed
The Power LED indicator
turns on red
If the Power LED indicator
is green, or flashing amber
If "Cable Disconnected" appears
on the screen
If "No Input Signal" appears on
the screen, or the Power LED
indicator is either amber or
alternating between green and
amber
Problem caused by a
connected computer or other
equipment, and not caused
by the display
Check these items
Check that the power cord and AC adapter are properly connected.
Press the display power button once.
The display is in remote off mode. Try pressing the power button of the display twice or remote card once.
Use the self-diagnosis function (page 39).
Check that the video signal cable is properly connected and all plugs are firmly seated in their sockets (pages 6, 10, and 12).
Check that the video input connector's pins are not bent or pushed in.
Check that the input select setting is correct (pages 5, 6, and 12).
A non-supplied video signal cable is connected. If you connect a non-supplied video signal cable, "Cable Disconnected" may appear on the
screen before entering the power save mode. This is not a malfunction.
Check that the video signal cable is properly connected and all plugs are firmly seated in their sockets (pages 6, 10, and 12).
Check that the video input connector's pins are not bent or pushed in.
Check that the input select setting is correct (pages 5, 6, and 12).
The computer is in power saving mode. Try pressing any key on the keyboard or moving the mouse.
Check that your graphics board is attached to the computer properly.
Check that the computer or other equipment are powered "on."
- 35 -