Radio Operation; Helpful Hints - HQ TORCH-EMC-02 Manual De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 17
4.
Continuous cranking during one minute will allow the unit to work for approximately 3 to 5 minutes. The
working time for radio or flashlight will depend on the battery level and the cranking speed.
When the unit is fully charged, the radio will work for about 3 hours at a 1/3 volume level; the flashlight will
work for approximately 1 hour; the lantern will work for about 1.5 hours; all functions used together and
the batteries will be exhausted in approximately 1 hour.
Caution Note
It is normal to hear noise when you crank the dynamo power generator.
If you are cranking too slow, the batteries will not be charged at all. We recommend to crack the handle
with about 120 turns a minute.
If the radio is set on and working for a long time and the batteries are exhausted, it shortens the battery
life and it will be hard to recharge by cranking again. So please don't leave the radio or flashlight on untill
the battery is gone. If that happens, it is normal that battery is not holding the power well when you try
hard to crank it after the battery is left drain to no power.
If so, you have to use an AC adaptor to restore and charge the batteries to wake up and keep the
battery a life. We strongly recommend you to charge the radio every month no matter you use it or not.
Furthermore, never leave the unit on before it is too low in batteries.

RADIO OPERATION

1.
Rotate the Volume Knob clockwise to turn the radio on and adjust to the desired sound level.
2. Slide the FM/AM Band to first band to select the FM band.
3.
Slide the FM/AM Band to the second band to select the AM frequency.
4.
Rotate the Tuning knob to the desired station.
5.
Turn off the power by rotating the Volume Knob to Power Off / minimum position till a "click" sound is
heard after use.
LIGHT
1.
Slide the Torch-Hi/Lo/Off/Lantern to the Torch-Hi position, and all LEDS will light up all the times.
2.
Slide the Torch-Hi/Lo/Off/Lantern to the Lo position, and several LEDS will light up all the times.
3.
Slide the Torch-Hi/Lo/Off/Lantern to the Lantern position, and the LANTERN will light up on the handle all
the times.
4.
Turn off the lantern by slide the Torch-Hi/Lo/Off/Lantern to the OFF position.
LCD CLOCK
Press and hold the Time Set button, then press the Hour and Min button to adjust the time.

HELPFUL HINTS

*
If the set is not used for a long period of time, remove all the batteries to prevent potential damage due to
possible battery leakage.
*
Do not subject the set to a temperature of over 60 C ( 140 F ) because characteristics of the internal
parts may be adversely affected by heat, especially never leave the set in a car exposed to direct sunlight
for a long period of time with the doors and windows closed. The cabinet may become deformed and
deterioration of the performance may result.
*
Since a strong magnet is used for the speaker, keep magnetized commuter passes, tickets or personal
credit cards, recorded tapes, watches etc. away from the radio. The speaker magnet in the radio may
damage them.
*
Do not place the set near strong magnets such as those used in radio, television sets, speaker boxes etc.
as these may cause the frequency to drift.
*
Do not drop or give the set a strong impact since the set is composed of precise parts.
*
When listening in a train car or building, use the radio near a windows to obtain the best possible
reception. Reception may be difficult in a tunnel or subway. Also note that operating the radio on a metal
object may adversely affect reception.
*
Do not use benzene thinner or any abrasive powder to clean the cabinet, wipe it with a soft cloth
moistened with a mild soap and water solution.
*
Avoid spray-type insecticides, some insecticides contain chemicals that could cause cabinet deformation.
3

Publicidad

Tabla de contenido
loading

Tabla de contenido