AGP SCS7 Instrucciones De Seguridad página 10

To switch off:
Release the trigger switch to stop the machine. After the machine has been switched off, the blade will still
rotate for a time, take care that parts of your body do not come into contact with the blade while it is still
rotating !
ELECTRONIC OVERLOAD PROTECTION
If while cutting the machine reaches a load approaching overload level, the electronic overload protection will
kick in and shut the saw off. When this happens, release the trigger and return the machine to its topmost
position (out of the cut) and wait at least 3 seconds before continuing.
HOW TO USE THE TOOL
Support the work properly and to hold the saw firmly WITH BOTH HANDS to prevent loss of control which
could cause personal injury.
OPERATION
1.
Adjust the depth of cut.
2.
Draw a cutting line before beginning cutting.
3.
Place the machine in position on the workpiece.
4. While the blades are not yet in contact with the workpiece, press the lock button squeeze the trigger and
allow the machine to reach full speed.
5. Holding firmly with both hands, slowly advance the machine until it makes contact with the workpiece.
Begin moving forward along the line of cut Take care that the base remains firmly on the workpiece.
CAUTION: Take care not to cut in a curved line. This will likely shatter the diamond blades causing a
severe hazard.
6.
When the cut is finished, allow the coasting blade to come to a full stop before setting down.
NOTE: Only operate the machine forwards relative to itself and never backwards. If you cut backwards
there is the danger that the machine might be accelerated out of the cutting groove (recoil) and cause
serious injury.
CAUTION: Keep the cord away from cutting area to prevent it from becoming entangled in the
workpiece.
GB
10