Fitting Instructions - Brink 2972 Instrucciones De Montaje

GB
Couplings class
Approval number
D- Value
Max. trailers dimensions
Max. vertical load

FITTING INSTRUCTIONS:

General:
The vehicle is fitted at the factory with holes for the towbar fitting, so you
do not need to drill any yourself. Remove the bitumen at the towbar fit-
ting points.
1. Where applicable: Remove all accessories from the towbar.
Remove the spare wheel, which is fitted under the vehicle. Position the
towbar and fix at Points A with two M10x80 bolts with filling plates,
spring-, plain washers and nuts.
2. Place support C on the left and secure the two spacers (ø30x11
L=14mm) at points B using two M10x50 bolts including flat and spring
washers and nuts. Place mounting support D on the right and secure it
at points B using two M10x70 bolts including spacers (ø30x11 L=14mm)
spacers (ø30x11 L=20mm) flat and spring washers and nuts.
3. Clear the boot floor and remove the rubber plugs from the floor at Points
E and F. Place the backplates with welded bolts through these holes in
the chassis. Push the threaded ends through holes E and F and fix at
these points with two M10 nuts with spring and lock washers. Replace
the rubber stops and floor covering.
4. The ball hitch is fitted to the tow bar with one M12x65/21.2 bolt and one
M12x65/21.2 bolt with socket plate, lock washers and self-locking nuts.
Tighten all nuts and bolts to the torque stated in the Table.
: A 50-X
: e11 00-0990
: 7,3 kN
: 1300 kg
: 80 kg
NOTE:
* Remove the insulating material from the contact area of the fitting points.
* All bolts are quality 8.8 - nuts 8. or when mentioned in fitting instructions
10.9 / 10.
* Don't forget the spring- and plain washers.
* Please consult your car dealer, or owners manual for the max. permissi-
ble towing mass.
* It is recommendable to retighten all fixing bolts and nuts after the towbar
has been in use for some 1000 km/600 miles.
* Do not drill through brake-or fuellines.
* Remove (if present) the plastic caps from the spot welding nuts.
Torque settings for nuts and bolts (8.8):
M10 46 Nm
M12 79 Nm 71 Nm (with self-locking nut)
© 297270/11-02-2002/4