SAFETY INFORMATION FOR WIRELESS HANDHELD PHONES
READ THIS INFORMATION BEFORE USING YOUR HANDHELD
PORTABLE CELLULAR TELEPHONE
EXPOSURE TO RADIO FREQUENCY SIGNALS
Your wireless handheld portable telephone is a low power radio transmitter
and receiver. When it is ON, it receives and also sends out radio frequency (RF)
signals. In August 1996, the Federal Communications Commissions (FCC) adopted
RF exposure guidelines with safety levels for handheld wireless phones. Those
guidelines are consistent with the safety standards previously set by both U.S. and
international standards bodies:
ANSI C95.1 (1992) *
NCRP Report 86 (1986) *
ICNIRP (1996) *
Those standards were based on comprehensive and periodic evaluations of the
relevant scientific literature. For example, over 120 scientists, engineers, and
physicians from universities, government health agencies, and industry reviewed
the available body of research to develop the ANSI Standard (C951).
The design of your phone complies with the FCC guidelines (and those standards).
1: American National Standards Institute.
2: National Council on Radiation Protection and Measurements.
3: International Commission on Nonionizing Radiation Protection.
ANTENNA SAFETY
Use only the supplied or an approved replacement antenna. Unauthorized
antennas, modifications, or attachments could impair call quality, damage the
phone, or result in violation of FCC regulations. Please contact your local dealer for
replacement antenna.
146
Do not use the phone with a damaged antenna. If a damaged antenna comes
into contact with the skin, a minor burn may result. Please contact your local
dealer for replacement antenna.
BATTERY SAFETY
Your device uses a removable and rechargeable lithium ion battery. Please contact
customer service for assistance should you need a replacement battery.
ChARGER
The Wall/USB Charger for this unit requires the use of a standard 120V AC power
source for its operation.
Never attempt to disassemble or repair the Wall/USB Charger. Never use the Wall/
USB Charger if it has a damaged or worn power cord or plug. Always contact a
PCD authorized service center, if repair or replacement is required.
Never alter the AC cord or plug on your Wall/USB Charger. If the plug will not fit
into the available outlet, have a proper outlet installed by a qualified electrician.
Never allow any liquids or water to spill on the Wall/USB Charger when it is
connected to an AC power source.
Always use the authorized Wall/USB Charger to avoid any risk of bodily injury or
damage to your cellular phone or battery.
Never attempt to connect or disconnect the Wall/USB Charger with wet hands.
Always unplug the Wall/USB Charger from the power source before attempting
any cleaning. Always use a dry, soft cloth dampened with water to clean the
equipment, after it has been unplugged.
Handling the cord on this product or cords associated with accessories sold with
this product, will expose you to lead, a chemical known to the State of California to
cause birth defects or other reproductive harm. Wash your hands after handling.
Always disconnect the Wall/USB Charger from the power source when it is not
in use.
If the plug is not inserted completely, it may cause electric shock, heat generation
01
02
02
03
04
05
147