Operating Instruction - Newteck Rhapsody Manual De Instrucciones

- oPeRating instRuction -

Firstly, plug in the appliance to a power source matching that on the
units rating label.
Power switch (located below the removable air filter at the rear of the
unit). Press the power button to "I" position. You should hear a beep
sound; the heater is now ready for use. Pressing the button to "0" pos
ition turns off the heater.
contRol Panel and led disPlaY WindoW
standBY
Press the key sleep mode button " ", and the indicator will light up.
The heater starts running at a low heat output and the LED on the
heating function displays "LOW".
Press this button again and all functions stop. The LED indicator turns
off and the unit returns to standby mode.
* When the heater is in standby mode, the power output is approximately
1.6W.
heating
When the unit is operating on a low heat, press the " ", button and the
high heating power will turn on and the LED display will show "HIGH".
Pressing this key lets you select for low or high power options.
osc (swing)
When the unit is operating on a low heat, press the " ", button and the
high heating power will turn on and the LED display will show "HIGH".
Pressing this key lets you select for low or high power options.
set
When the unit is running, press the " " button to set the timer or
thermostat.
note: After pressing the "
" button to set the timer or change the
required temperature, the LED flashes for about 5 seconds.
During this interval of 5 seconds, changes may be made by pressing
"+" or "-".
However, if no more buttons are pressed after pressing the " " button,
46