Remote Control - Newteck Rhapsody Manual De Instrucciones

the unit will return to room temperature
and the process must be repeated to
make farther changes.
note: When the heater is turned off,
the activated fan remains for a few
seconds to help cool the heater. After
those seconds the heater will turn off
completely and remain silent.
a: setting the timer:
Press the "SET" button, and the light
shows "0 h". Press the "+" or "-" button
to set the working time (within a range of 1-12 hours).
The time can be increased or decreased by 1 hour by pressing "+" or "-"
respectively. The display will show the time from the last time it was set.
B: setting the thermostat:
After setting the timer (if desired), press the "SET" button again. The LED
displays 25°C, and the thermostat can now be set to the temperature
required. The temperature can be increased or decreased by 1°C by
pressing "+" or "-" respectively. The display will show the temperature
from the last time it was set. The setting range is 15- 35°C.
When the ambient temperature is ≤ 10°C, the LED screen will display
"LO". When the ambient temperature is > 40°C, the LED screen will
display "HI".
The temperature marked on the LED display when the heater is running
is the room's ambient temperature. It will be displayed when the
temperature is between -10ºC and 40ºC.

- Remote contRol -

Replacing the battery in the remote control
· Slide the battery holder out into from the back of the remote control.
(Picture1)
· Insert a 3V Li (CR 2032) battery inside, with the letters facing up.
(Picture 2)
· Slide the battery holder back into the remote control. It is now ready
to use.
47