AEG EA 150 Instrucciones De Uso página 15

EA150.book Seite 15 Montag, 14. März 2005 10:37 10
Steam nozzle
0 Remove the attachment from the
steam nozzle and rinse the attachment
in normal rinse water.
0 Wipe the steam nozzle clean using a
damp cloth. You can use the
maintenance guide (figure 1/L) to
screw off the nozzle head to clean it or
decalcify it.
Drip grating and drip tray
The drip tray must be emptied when
the level indicator (figure 1/U) is
protruding above the drip grating.
0 Insert your fingers into the holes in the
drip grating. Remove the drip grating
and rinse it under running water
(figure 12).
0 To empty it, hold the drip tray on both
sides and pull it forwards and out of
the appliance (figure 13).
0 Remove the plastic attachment with
the level indicator and rinse both
under running water (figure 14).
0 Place the plastic attachment with the
level indicator back into the drip tray.
0 Push the clean drip tray back into the
appliance and place the drip grating
back in.
Cleaning the brew filter
The brew filter through which the hot
water flows is located on the brew
head. Check from time to time to
ensure that the holes in the brew filter
have not become blocked by coffee
particles.
If the holes have become blocked:
0 Unscrew the brew filter using a coin
(figure 15).
0 Remove the brew filter and seal
(figure 16/1) and remove the brew
filter's seal (figure 16/2).
0 Clean the brew filter with warm water
and a brush.
0 Rinse the seal with warm rinse water.
3
If the appliance is to be transported at
temperatures below zero:
0 Empty the water tank.
0 Turn the selector dial (figure 1/G) to
the position and let the appliance
dry.
Decalcifying
If the espresso is flowing through the
filter at a slower rate than usual, it is
time for the appliance to be
decalcified.
We recommend that you decalcify the
machine once every three months with
liquid decalcifier. If you live in an area
with hard water the decalcifying
procedure may have to be carried out
more often. When doing this follow
the instructions provided by the
manufacturer of the decalcifier.
Important: Prior to decalcifying,
remove the brew filter (figure 1/V) and
the brew filter's seal, as described in
the section "Cleaning the brew filter"
(figures 15, 16).
First pour the water into the water
tank, then add the decalcifier; never in
the reverse order. At least 0.5 litres of
water must be used. The decalcifier
should be added accordingly.
0 Remove the power plug from the
power point and allow the appliance to
cool.
0 Remove the steam nozzle with the
attachment (figure 1/H).
0 Place the filter holder in position
without the filter.
0 Place a sufficiently large container
under the filter holder.
0 Insert the power plug into the power
point and switch on the appliance.
0 Afterwards, turn the selector dial
(figure 1/G) to the
approx. ¼ of the decalcifier flow
through the system.
g
position and let
15