Publicidad
Idiomas disponibles
Idiomas disponibles
Attention!
•
This manual is for qualified technical personnel only for installation purposes and not
intended for the end user; it's the installer's job to explain to the user how the automatism
works, about possible hazards related to it and about the need for periodical
maintenance.
•
The automatism must be installed by qualified personnel only, observing current standards
concerning automatic closing systems. More specifically, installation conformity calls for
observance of directive 89/392 and standards EN 12453 and EN 12445.
•
As ALPHEO is made specifically to control swing gates it is forbidden to use the product for
different purposes or improperly.
•
Use original components only. Stagnoli is not liable for damages if other components are
used.
•
Make certain that the gate structure is solid and suitable for being motor-driven.
•
When the gate is moving make sure there are no points of friction and there is no chance
of it derailing.
•
Make absolutely certain the power is disconnected before carrying out any work on the
device.
•
Connect the power lead to supply lines with adequate electrical protection only; install a
device to guarantee disconnection of all the phases from the mains that has a distance of
at least 3.5 mm between the contacts.
•
Pay particular attention when deciding which safety devices to install and their location.
Always install an emergency stop device that will cut power off in the case of necessity.
•
Only qualified personnel must be allowed to service the unit and access the internal parts
of the geared motor.
•
Irreversibility of the geared motors means an electric lock does not have to be installed
and, in the case of black-out the release device (protected by a personalised key) lets
you open the gate by hand. We do however recommend using an electric lock to ensure
correct closing especially if the swing gates are longer than 2.5 metres.
Istruzioni, instructions Instrucciones
12
Publicidad
