What To Do If - Zanussi ZDF2030 Manual De Instrucciones

What to do if...

The appliance does not start or stops during operation.
If there is a fault, first try to find a solution to the problem
yourself. If you cannot find a solution to the problem
yourself, contact the Service Force Centre.
Fault code and malfunction
• continuous flash of the start/cancel in-
dicator light
• 1 flash of the end indicator light
The dishwasher does not fill with water
• continuous flash of the start/cancel in-
dicator light
• 2 flashes of the end indicator light
The dishwasher will not drain
• continuous flash of the start/cancel in-
dicator light
• 3 flashes of the end indicator light
The anti-flood device operates
The programme does not start
After the check, switch on the appliance. The programme
continues from the point of interruption. If the malfunction
shows again, contact your Service Force Centre.
These data are necessary to help you quickly and cor-
rectly:
• Model (Mod.)
• Product number (PNC)
Caution! Switch off the appliance before you do the
below suggested corrective actions.
Possible cause and solution
• The water tap is blocked or furred with limescale.
Clean the water tap.
• The water tap is closed.
Open the water tap.
• The filter in the water inlet hose is blocked.
Clean the filter.
• The connection of the water inlet hose is not correct. The hose can
be kinked or squashed.
Make sure that the connection is correct.
• There is a blockage in the sink spigot.
Clean the sink spigot.
• The connection of the water drain hose is not correct. The hose can
be kinked or squashed.
Make sure that the connection is correct.
• Close the water tap and contact your local Service Force Centre.
• The appliance door is not closed.
Close the door.
• Mains plug is not connected in.
Put in the mains.
• The fuse has blown out in the household fuse box.
Replace the fuse.
• Delay start is set.
Cancel the delay start to start the programme immediately.
• Serial number (S.N.)
For these data, refer to the rating plate.
Write the necessary data here:
Model description : ..........
Product number : ..........
Serial number : ..........
57