Closing The Door; Installation; Electrical Connection; Door Reversibility - AEG AGS56000S0 Manual De Instrucciones

28 www.aeg.com
Problem
The temperature in
the freezer is too
high.
There is too much
frost.

6.1 Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to "Installation".

7. INSTALLATION

7.1 Positioning
WARNING!
If you are discarding an old appli-
ance that has a lock or catch on
the door, you must ensure that it
is made unusable to prevent
young children being trapped in-
side.
The appliance shall have the
plug accessible after installation.
Install this appliance at a location where
the ambient temperature corresponds to
the climate class indicated on the rating
plate of the appliance:
Cli-
mate
class
SN
N
ST
T
Possible cause
The temperature regula-
tor is not set correctly.
Many products are stored
at the same time.
Products are too near to
each other.
Food is not wrapped cor-
rectly.
The temperature regula-
tor is not set correctly.
Ambient temperature
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C
Solution
Set a lower temperature.
Store less products at the
same time.
Store products so that
there is cold air circulation.
Wrap the food correctly.
Set a higher temperature.
3. If necessary, replace the defective
door gaskets. Contact the Service
Center.

7.2 Electrical connection

Before plugging in, ensure that the volt-
age and frequency shown on the rating
plate correspond to your domestic pow-
er supply.
The appliance must be earthed. The
power supply cable plug is provided
with a contact for this purpose. If the do-
mestic power supply socket is not earth-
ed, connect the appliance to a separate
earth in compliance with current regula-
tions, consulting a qualified electrician.
The manufacturer declines all responsi-
bility if the above safety precautions are
not observed.
This appliance complies with the E.E.C.
Directives.

7.3 Door reversibility

The door of the appliance opens to the
right. If you want to open the door to the
left, follow these steps before you install
the appliance: