Publicidad
e - 2
e - 5
e - 6
e - 7
e - 8
e - 9
-- : --
-- : --
e - 1 1
Always contact your Zibro dealer for any malfunctioning not listed above.
AUTOMATIC DEACTIVATION
This heater is fitted with a safety system that ensures that it switches off
automatically after 50 hours continuous operation. The following will then appear
in the display:
the
AUTOMATIC CLEANING MODE
When the heater has been burning continuously for two hours at its highest
setting, the burner will automatically start an autoclean procedure. The display
will show the autocleaning code cl:05 running back to cl:01. The procedure takes 5
minutes, during which the heater will burn at its lowest setting, while the burner
autocleans. When the burner is clean again, the heater will automatically switch
back to the highest setting again.
THE USE OF THE MOTION DETECTION SENSOR
This heater is equipped with a motion detection sensor. The sensor is placed at
the front side of the heater and it signals every single movement. The motion
detection sensor has a horizontal detection angle of 80
angle of 20
If the sensor does not detect movements for 10 minutes then the heater will
automatically switch to a lower combustion level. As a result less fuel will be used.
Switch on the motion detection sensor;
Switching on the motion detection sensor can only be done when the heater is
turned on. Push the "Motion" button
light will light up (green).
If the sensor does not detect movements for 10 minutes then the heater will
automatically switch to a lower combustion level. The motion detection sensor
light keeps lighted up. If the sensor detects movement the motion light will blink.
The heater switches back to the latest temperature setting.
Switch off the motion detection sensor;
The Motion detection sensor can be switched off by pressing the "Motion" button
Remote control
4
This heater is equipped with a remote control. The functions on the remote
control are the same as the functions on the display of the heater.
80
Starting problems.
Tipping-over protection.
Poor burning.
Room temperature
above 32°C.
Defective booster.
Air filter dirty; or
Fuel pump dirty.
The heater has been in operation
continuously for a period of 50 hours
and has turned itself off automatically.
Out of fuel.
+
Too little ventilation.
+
Too little ventilation.
+
. If desired, you can switch the heater on again by pressing
button M (see Section D).
. The sensor detects movements as far as 7 m.
o
again. A sound signal will be heard and the "Motion" light will go out.
Contact your dealer.
Re-ignite the heater.
Contact your dealer.
If necessary,
re-ignite the heater.
Contact your dealer.
Clean filter
Contact your dealer.
Switch the heater back on.
Refill removable tank.
Ventilate better.
Ventilate better.
and a vertical detection
o
. A signal will sound and the "Motion"
Publicidad
