Removing/Attaching Battery Pack; Charger/Adapter - Powerbuilt 641653 Manual De Instrucciones

REMOVE BATTERY PACK:
1. Press release button on the Cordless Drill to
release the battery pack.
2. Pull battery pack free of Cordless Drill.
ATTACH BATTERY PACK:
1. Slide the battery pack inside the base of the drill.
2. Press battery pack until it snaps into place. Do not
use the the drill if the battery pack is not seated
properly.
instructions and cautionary markings on battery charger, battery pack and
product using battery.
Use only the charger which accompanied your product or direct replacement
as listed in this manual. Do not substitute any other charger. Use only Alltrade approved
chargers with your product.
Do not disassemble charger.
Do not use charger if it has been damaged, left outdoors in the rain, snow, wet
or damp environments, or immersed in liquid.
The battery pack and charger heat during charging. Place the battery on a flat,
non-flammable surface away from flammable materials with at least four inches of clearance to
allow proper air circulation around the battery pack.
When the battery pack requires recharging, a 3-5 hour charge allows the tool to
operate at full power. A charging indicator light on the battery will illuminate to show that
charging is taking place.

REMOVING/ATTACHING BATTERY PACK

CHARGER/ADAPTER

Before using battery charger, please read carefully all
RELEASE
BUTTON
11