Charging Battery Pack; Battery Led Indications - Powerbuilt 641653 Manual De Instrucciones

CHARGE BATTERY PACK:
1. Make sure the trigger on the
Cordless Driver is in the "OFF"
position and remove the battery
pack from the Cordless Driver.
2. Plug 120V AC adapter into house-
hold outlet and insert the adapter
plug inside the charging port on
the top of the battery pack. The red
LED on the top of the battery pack
turns on indicating battery being
charged.
3. After 3-5 hours of charging,
the empty battery becomes
fully charged and Red LED
turns off and Green LED turns
on. Remove the battery pack from charger and reattach battery pack onto Cordless Driver,
making certain latches fasten securely. Cordless Driver will not operate properly if the battery
pack is not seated properly.
IMPORTANT INFORMATION FOR RECHARGING HOT BATTERIES
When using your Cordless Driver continuously, the batteries in your battery pack will
become hot. You should let a hot battery pack cool down for approximately 30 minutes
before attempting to recharge.
Drill causes the battery pack to become hot. It does not occur under normal
circumstances.
Solid Red: Battery Charging
Solid Green: Battery Charged/Full
Blinking Red: Battery Hot

CHARGING BATTERY PACK

This will occur when continuous use of your Cordless

BATTERY LED INDICATIONS

120V AC
ADAPTER/CHARGER
CHARGING PORT
12
LED's
BATTERY
PACK