Assembly And Operation; Installation - Eisl Sanitär MIOMARE 283016 Manual Del Usuario

General Information and Safety Notes / Assembly and operation
Improper installation could result in injury. Dam-
aged parts could impact safety and function.
Do not hold on to or support yourself by the
shower rod .
1
The materials have not been designed for such
resulting forces.
When adjusting the hot water temperature be
sure the water temperature is not too high.
CAUTION! RISK OF SCOLDING! The
temperature of the water in the shower can be
altered by adjusting the shower head
the hand shower head
water temperature before you enter the water
spray jet.
CAUTION! RISK OF INJURY! Please refer
to the operating instructions of your electric drill.
Avoid damage to
property!
CAUTION! WATER DAMAGE! Switch off
the general water supply.
Be sure all seals are correctly seated.
The shower kit is not suitable for use with low-
pressure tanks and small-scale tank heaters.
We recommend fitting a filter, in order to pro-
tect the incoming end of the tap and, in doing
so, protect the cartridge from damage by for-
eign bodies.
This product is only suitable for use in rooms
with temperature above 0 °C. In case of poten-
tial frost, cut off the water supply and drain the
taps.
Any leakage or sudden escape of water can
cause considerable damage to buildings and
property. All connections must therefore be
checked carefully to ensure that they are tight.
Familiarise yourself prior to installation with all
local conditions, e.g. water connections and
shut-off device.
Seals are subject to wear. They must be changed
from time to time.
Before attaching the product to the wall, check
which mounting materials are suitable for your
wall. We have supplied fixings suitable for an
ordinary solid masonry wall.
283016_mio_Brauseset_Content_OS.indd 13
and
3
. Please check the
4

Assembly and operation

Installation

Note: Please carefully read the fitting instructions
prior to installation. Please note, incorrect installa-
tion will void all warranty – particularly in relation
to subsequent damage.
CAUTION! Shut off the water supply prior to
installation. Before drilling holes for the fastener
and the wall mounting plate
the presence of hidden supply cables e.g. with a
cable or metal detector. Failure to do so may result
in property damage.
Drill 2 x 2 holes in the positions in which you
want to fix the fastener
ing plate to the wall (see Fig. B).
13
Insert the wall plugs
9
(see Fig. B).
Push the fastener onto the shower bar
10
from below.
Screw it fast with the screws
Then fasten the shower bar
screws fixed inside
5
Use a Philips head screwdriver for this. Now place
the cap on the shower bar
(see Fig. C).
Then push the hand shower holder
shower bar from below. To do this, open the
clamp fixture by turning the cap fixture so that
the inner fastening rings lie flush one above the
other.
Insert a seal into the swivel nut on the
2
shower head and screw the shower head
3
onto the shower rod
3
Using the screws, screw the wall mounting
plate onto the wall.
13
Now push the push button diverter
wall mounting plate.
Fix the cap of the push button diverter
that the push button diverter cannot come loose.
Now use the pre-assembled retainer nut and a
seal to screw the shower bar and the push
2
button diverter together.
8
After that, place a seal
of the shower hose
6
back thread of the push button diverter
10
check the area for
13
and the wall mount-
10
into the drilled holes
1
(see Fig. C).
11
using the
1
.
fastener
1 10
onto the
12
(see Fig. D).
1
over the
8
so
14
in the hexagon nut
2
and screw these to the
.
8
GB/IE 13
27.06.17 10:29