HQ-Power VDPLP56SB Manual Del Usuario página 4

• Use an appropriate safety cable to fix the device (e.g. VDLSC7 or VDLSC8).
• Familiarize yourself with the functions of the device before actually using it. Do not allow operation by unqualified
people. Any damage that may occur will most probably be due to unprofessional use of the device.
• Use the original packaging if the device is to be transported.
• All modifications of the device are forbidden for safety reasons.
• Only use the device for its intended purpose. All other uses may lead to short circuits, burns, electroshocks,
crash, etc. Using the device in an unauthorized way will void the warranty.
4. Installation
a) Fixture
• Choose a suitable mounting location and mount the light in the desired angle.
• Use a waterproof cover when using the light outdoors.
• Insert the power cord into an appropriate outlet (230VAC / 50Hz).
• Switch off the power to the light when not in use.
• This LED parcan is controlled through a 3-pin XLR (1 = GROUND, 2 = DATA-, 3 = DATA+).
b) Fuse
• Only fit or replace a fuse when the device is unplugged from the
mains.
• Replace a blown fuse with a fuse of the same type and rating
(see "Technical Specifications"):
1. Remove the fuse holder (1) at the back using an
appropriate screwdriver.
2. Remove the old fuse and install a new one.
3. Replace the fuse holder and fasten tight with the
screwdriver.
c) Mounting the Device
• Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable norms.
• The carrying construction must be able to support 10 times the weight of the device for 1 hour without deforming.
• The installation must always be secured with a secondary attachment e.g. a safety cable.
• Never stand directly below the device when it is being mounted, removed or serviced. Have a qualified technician
check the device once a year and once before you bring it into service.
• Install the device in a location with few passers-by that is inaccessible to unauthorized persons.
• Overhead mounting requires extensive experience: calculating workload limits, determining the installation
material to be used... Have the material and the device itself checked regularly. Do not attempt to install the
device yourself if you lack these qualifications as improper installation may result in injuries.
• Adjust the desired inclination angle via the mounting bracket and tighten the bracket screws.
• Make sure there is no flammable material within a 0.5m radius of the device.
• Have a qualified electrician carry out the electric connection.
• Connect the device to the mains with the power plug. Do not connect it to a dimming pack.
• The installation has to be approved by an expert before the device is taken into service.
VDPLP56SB / VDPLP56SC_v2 4 VELLEMAN