Chicco oasys 2-3 Evo Fix Plus Instrucciones De Uso página 24

ADJUSTING THE INCLINATION OF THE
CHILD CAR SEAT BACKREST/SEAT
It is possible to recline the child car seat by us-
ing the reclining adjuster button (H).
The child car seat backrest/seat can be reclined
to 4 different positions to allow the child to
travel in absolute comfort.
To recline the backrest simply grasp hold of
the front section of the seat (Fig. 36) and pull
it towards you.
Simply press the reclining adjuster button (H)
pushing the seat backwards towards the vehicle
seat backrest to return it to a vertical position.
WARNING! never recline the child car seat
when in use. Before adjusting the backrest, re-
move the child from the child car seat.
After reclining or straightening the Oasys child
car seat, always check that the car 3-point safe-
ty belt is sufficiently taut and a maximum of 2
cm above the shoulder of the child (Fig. 31).
Always perform the above operations when
the vehicle is at a standstill.
REMOVABLE BACKREST/SEAT COVERS
The child car seat fabric cover is completely re-
movable and washable. It is attached to the struc-
ture using velcro straps and elastics (Fig. 37).
Straighten the backrest (C) upright and widen
the side flaps (N).
BACKREST
Start from the lower section of the side flaps,
separate the fabric lining from the Velcro fas-
teners (Fig. 38) and lift it off.
Now separate the central section of the back-
rest working from the bottom upwards, remov-
ing the entire cover, including the headrest
section, undoing any elastic fasteners found
behind the backrest. (Fig. 39)
SEAT
1. O pen the velcro fastener on the back of the
seat (Fig. 40).
2. P ull the fabric cover so the elastic is taut, then
remove it from the lap belt loop (F) on both
sides (Fig. 41).
3. G rasping both elastics, remove this section of
the fabric cover from the lap belt loops (F) on
both sides (Fig. 42).
4. T he central protection is fastened to the
backrest by two toothed fixtures, pull the
central protection upwards, releasing the
toothed fixtures from their seats (Fig. 43).
5. P ull the cover up over the armrests and remove.
6. N ow finish the removal process by pulling
the triangular plastic reinforcement, fitted
around the reclining adjuster button (H), up-
wards (Fig. 44A and 44B).
TO REPLACE THE COVER ON THE FRAME:
Straighten the backrest upright and widen the
side flaps.
SEAT
Start by covering the seat, repeating opera-
tions 6 to 1 in the reverse order, paying particu-
lar attention that the cover fits over all parts of
the frame perfectly, especially around the two
lap belt guides (F) threading the elastics under
each of them.
BACKREST
Start from the headrest making sure you insert
the elastic and the section of the fabric in the
rear cover. Now fit the cover on, following the in-
structions for operations 1 and 2 in reverse order.
CLEANING AND MAINTENANCE OF THE
SEAT COVERS
The cleaning and maintenance operations
must only be carried out by an adult.
HOW TO CLEAN THE FABRIC COVER
The child car seat fabric cover is completely
removable and washable. Please refer to the
care label for instructions on cleaning the fab-
ric cover:
30° C
24
Machine washable at 30°C.
Do not bleach
Do not tumble dry
Do not iron
Do not dry clean
Ne
Do
ou
Th
an
sin
an
WA
sea
CL
Cle
or
ter
ch
CH
PO
It i
dit
tha
• f a
co
ti
an
• p
n
WA
wo
co
ST
Wh
ed
aw
fro
DI
Wh
wit
an
po
the
Co
WA
Th
for
pro